<pre id="bbfd9"><del id="bbfd9"><dfn id="bbfd9"></dfn></del></pre>

          <ruby id="bbfd9"></ruby><p id="bbfd9"><mark id="bbfd9"></mark></p>

          <p id="bbfd9"></p>

          <p id="bbfd9"><cite id="bbfd9"></cite></p>

            <th id="bbfd9"><form id="bbfd9"><dl id="bbfd9"></dl></form></th>

            <p id="bbfd9"><cite id="bbfd9"></cite></p><p id="bbfd9"></p>
            <p id="bbfd9"><cite id="bbfd9"><progress id="bbfd9"></progress></cite></p>
            試題

            計算機四級考試網絡工程師練習題

            時間:2025-03-21 19:26:25 試題 我要投稿
            • 相關推薦

            計算機四級考試網絡工程師練習題2017

              題目不能做過就忘,一定要善于總結經驗,發現規則。下面是小編整理的計算機四級考試網絡工程師練習題,希望對大家有用,更多消息請關注應屆畢業生網。

            計算機四級考試網絡工程師練習題2017

              1、進入特權模式 enable

              router > enable

              router #

              2、進入全局配置模式 configure terminal

              router > enable

              router #configure terminal

              router (conf)#

              3、交換機命名 hostname routera 以routerA為例

              router > enable

              router #configure terminal

              router(conf)#hostname routerA

              routera (conf)#

              4、配置使能口令 enable password cisco 以cisco為例

              router > enable

              router #configure terminal

              router(conf)#hostname routerA

              routerA (conf)# enable password cisco

              1、進入特權模式 enable

              router > enable

              router #

              2、進入全局配置模式 configure terminal

              router > enable

              router #configure terminal

              router (conf)#

              3、交換機命名 hostname routera 以routerA為例

              router > enable

              router #configure terminal

              router(conf)#hostname routerA

              routera (conf)#

              4、配置使能口令 enable password cisco 以cisco為例

              router > enable

              router #configure terminal

              router(conf)#hostname routerA

              routerA (conf)# enable password cisco

              7、設置端口ip地址信息

              router > enable

              router #configure terminal

              router(conf)#hostname routerA

              routerA(conf)# interface fastehernet 0/17 以17端口為例

              routerA (conf-if)#ip address 192.168.1.1 255.255.255.0 配置交換機端口ip和子網掩碼

              routerA (conf-if)#no shut 是配置處于運行中

              routerA (conf-if)#exit

              8、查看命令 show

              router > enable

              router # show version 察看系統中的所有版本信息

              show interface vlan 1 查看交換機有關ip 協議的配置信息

              show running-configure 查看交換機當前起作用的配置信息

              show interface fastethernet 0/1 察看交換機1接口具體配置和統計信息

              show mac-address-table 查看mac地址表

              show mac-address-table aging-time 查看mac地址表自動老化時間

              show controllers serial + 編號 查看串口類型 show ip router 查看路由器的路由表

              9、路由器telnet遠程登錄設置

              router>enable

              router #configure terminal

              router (conf)#hostname routerA

              routerA (conf)#enable password cisco 以cisco為特權模式密碼

              routerA (conf)#interface fastethernet 0/1 以17端口為telnet遠程登錄端口

              routerA (conf-if)#ip address 192.168.1.1 255.255.255.0

              routerA (conf-if)#no shut

              routerA (conf-if)#exit

              routerA (conf)line vty 0 4 設置0-4 個用戶可以telnet遠程登陸

              routerA (conf-line)#login

              routerA (conf-line)#password edge 以edge為遠程登錄的用戶密碼

              10、配置串口參數

              兩臺路由器通過串口連接需要一個做為DTE,一個做為DCE。DCE設備要向DTE設備提供時鐘頻率和帶寬。

              DCE配置:

              router>enable

              router #configure terminal

              router (conf)#hostname routerA

              routerA(conf)#interface serial 0/0

              routerA(conf_if)#clock rate 64000 提供時鐘頻率為64000

              routerA(conf_if)#bandwidth 64 提供帶寬為64

              DTE配置:路由器串口配置ip地址

              router>en

              router #configure terminal

              router (conf)#hostname routerB

              routerB(conf)#interface serial 0/0

              routerB(conf_if)#ip address 192.168.1.1 255.255.255.0

            【計算機四級考試網絡工程師練習題】相關文章:

            計算機四級考試網絡工程師練習題及答案08-14

            計算機四級考試網絡工程師練習10-04

            計算機四級考試網絡工程師試題09-04

            2015年計算機四級考試網絡工程師過關練習題及答案10-13

            計算機四級考試網絡工程師考點精選201508-02

            2015計算機四級考試網絡工程師重點08-06

            計算機四級考試網絡工程師常見考點04-30

            計算機四級考試網絡工程師考點:Internet08-18

            2017計算機四級考試網絡工程師考點09-05

                    <pre id="bbfd9"><del id="bbfd9"><dfn id="bbfd9"></dfn></del></pre>

                    <ruby id="bbfd9"></ruby><p id="bbfd9"><mark id="bbfd9"></mark></p>

                    <p id="bbfd9"></p>

                    <p id="bbfd9"><cite id="bbfd9"></cite></p>

                      <th id="bbfd9"><form id="bbfd9"><dl id="bbfd9"></dl></form></th>

                      <p id="bbfd9"><cite id="bbfd9"></cite></p><p id="bbfd9"></p>
                      <p id="bbfd9"><cite id="bbfd9"><progress id="bbfd9"></progress></cite></p>
                      飘沙影院